9 thoughts on “ Extrusion - DSE* - Face Cutter (Cassette) ”

1. Feb 24,  · The variations in this design is an Offset Rotary Die Face Cutter; which can used when tougher material requires more power and torque to achieve the optimal cut.

   Reply
2. Guillotine Extruder Cutter - Diamond America Knowledge Experience Top quality downstream extrusion equipment ☎

   Reply
3. The Dynaforce Rotary Cutter is fitted with a spring-loaded swivel blade holder to ensure even, full blade contact of the cutting blade to the die face. Diamond America produces three standard models of rotary cutter, in 2”, 4” and 6”- 8” sizes, the RC, RC and the RC, respectively.

   Reply
4. to typical extrusion conditions before start up by sealing the container to a die stack with the shear blade above. c) Shear blade clearance will be influenced by: Toolstack overall length variation - Wear of the die slide guideways (both bottom and rear) - Distortion in the die cassette and/or damage to the cassette horseshoe.

   Reply
5. Die as per customize (Depends on Screw, Output, Material, Pressure Etc) Complete water tank / fabricated ways to separator. Separator with rotor & Motor. Cyclone attached to separator. Bottom water tank with partition, inlet and outlet. Electrical Panel with A.C. drive for variable speed of cutter.

   Reply
6. Welcome to Rajhans - India's leading manufacturer of screen changers and melt pump systems. We excel in varied world-class industrial products that are known for being highly reliable, we manufacture products that give great results in any extrusion-processing environment.

   Reply
7. Aug 27,  · A cutter-shaft assembly transiting the chamber spins a knife hub over the die face. Polymer strands extruding through the holes are cut into uniform-length pellets by the passing blades. The pellets are instantly jacketed and cooled and then conveyed into an overhead transfer pipe for added cooling time.

   Reply
8. 1 “Pelletizing System Options for Extrusion” by Dana Darley Extrusion Auxiliary Services Dacula, GA () amletpaczmenswabournewshandduthulasphe.coinfo Types of Pelletizing Systems Strand –Water Bath Strand –Water Slide Hot Die Face –Air Cooled Die Face –Water Ring Die Face –Under Water Drop Pelletizing Strand –Water Bath - Strengths Low cost.

   Reply
9. The melt emerging from the holes in the heated pelletiser die face (1) are cut off by rotating knives (2).The pellets are flung outward by the centrifugal force into a rotating water ring (3).This cools the pellets and transports them via a flexible discharge channel to the to the pellet water removal screen (4).The pellets pass through the oversize particle separator to the drying centrifuge.

   Reply